“I am more and more dissatisfied with my kitchen at home recently. I feel that there are many defects in decoration and design. Although the period of use is not long, I want to replace the cabinet and redecorate it. If you change a new kitchen, believe in yourself. It will be more experienced than the original." Ms. Ye, who lives in a certain district in Jiangnan, said. She hopes to share her lessons with everyone, for more reference and reference for owners who have no experience in decoration. The height of the countertop should be moderate Ms. Ye said that the countertop height of her kitchen cabinet was a bit low. Every time I wash the dishes, I feel that my waist is very tired. If the cabinet countertop is about 5 centimeters higher than it is now, it will definitely be much better. To this end, she suggested that when designing the whole cabinet, the height of the countertop should be determined according to the height of the main user of the kitchen (usually the time the hostess uses the kitchen), and it is not tired when bending over. The designer suggested that the height of the lower cabinet can be determined by formula according to the height of the main user of the kitchen. The general formula for the height of the lower cabinet is: height/2 + 5 = height of the lower cabinet (cm). For example: If the main user of the kitchen is 150 cm tall, the height of the lower cabinet should be: 150/2+5=80 cm. If the embedded cabinet, disinfection cabinet, dishwasher, small refrigerator and other electrical appliances are installed in the lower cabinet, then the lower cabinet should be determined according to the height of the electrical appliance, or be made into a high and low fault layer. It should be noted that the height of the upper cabinet should not exceed the height of the lower cabinet, otherwise the kitchen will look top-heavy and make people feel uncomfortable. It is best to make the upper cabinet narrower to avoid the embarrassment of the owner when they use it. At the same time, the distance between the upper and lower cabinets should be between 70 and 75 cm. If the distance between the upper and lower cabinets exceeds 75 cm, it will exceed the suction range of the range hood and affect the effect of the range hood. The position of the cooktop is particular Ms. Ye said that she still has a very dissatisfied place in her kitchen, that is, the gas stove is facing the opening of the window. This makes her a more embarrassing situation every time she cooks. Do not open the window, the smell of indoor gas is a bit heavy, smell uncomfortable; open the window, the wind outside is just blowing on the fire, the fire is big and small, affecting the heat. To this end, she believes that the kitchen should be decorated with the location of the stove, be sure to avoid the vents. Ms. Ye’s cabinets are made of marble countertops that are not resistant to dirt and are not easily rubbed after dyeing. Designers suggest that the countertops may wish to choose artificial stone. The artificial stone countertop has the advantages of wear resistance, acid resistance and high temperature resistance. There is no pore on the surface of the countertop, and dirt such as oil stains and water stains will not penetrate into it, and it is more resistant to dirt. The designer also suggested that the kitchen concealment project must be done well, especially the internal socket position should be designed and planned in advance, and more sockets should be designed. In addition, it is best not to install a socket above the cooktop. Do not place the refrigerator next to the stove. Otherwise, the refrigerator will increase the cooling cost due to the high temperature around the stove. Do not put the garbage basket in the cabinet Another flaw in the cabinet design of Ms. Ye’s home is that the garbage basket is placed inside the whole cabinet. “At the time, I felt that this design looked clean and beautiful, and it also improved the space utilization of the kitchen. Only after using it, I know that this is not the case.†Ms. Ye said that the kitchen waste often gives off a taste. Especially in the hot summer weather, when you open the door, you will smell a stink, and feel that those cleaned dishes are "contaminated" by this smell. She suggested that you should never design the garbage basket inside the whole cabinet, you may wish to place a garbage basket directly in the kitchen. A qualified home can also install a garbage processor. In this way, the kitchen waste can be washed away directly. When many people are decorating the kitchen, the tiles are only attached to the half wall, and the back of the wall cabinet is often not tiled. In fact, the tiles covered with the entire wall can effectively prevent the fumes. Tiles do not darken the walls, and are easy to clean and not afraid of water. The dirt on the wall can be solved with a lighter and a wipe. Reasonable design of the moving line process The designer suggested that it is very important to design the kitchen's moving line process. On the one hand, it is arranged according to the moving line from the ingredients, cleaning, conditioning and cooking, which is convenient for the owner to operate one by one, which is convenient and efficient. On the other hand, it is best to place the oven and stove that will produce high temperature and soot in the same interval, and the refrigerator and sink are placed on the other axis to achieve better energy saving. In summer, the weather is hot. The owner has to suffer from high temperature in the kitchen. For those who have the condition, it is recommended to install an air conditioner in the kitchen or leave the position of the electric fan. Finally, the designer suggested that when the kitchen is renovated, it is strictly forbidden to move the gas meter. The gas pipeline must not be used as a dark pipe. At the same time, it should be convenient to read the meter. Do not walk the gas pipe between the gas pipe and the kitchen gas water heater. You can vacate the PVC concealed pipe on the wall so that you do not need to punch holes in the platen. Source: News Jinhua, author: Dai Weiwen Jc001.load('news_ads'); jc001.newsAds.prints("4") Checker plate includes various kinds of tread.Normally there are big five bar,small five bar,two bar,stucco,,pointer,diamond and so on. Aluminum Checker Plate,Aluminium Tread Plate ,Aluminum Plate 6061,Aluminum Film Plate Henan Everwin Trade Co., Ltd. , https://www.ewaluminium.com
Five bar Aluminum Sheet with great antiskid property and widly used on the floor.
Stucco aluminum sheet is widly used in refrigerator,air conditioner and packing.
The alloy 1050 1060 1100 1235 checker plate is used in freezer,floor and packing.
3000 series checker plate,mainly 3003,have strong rust-proof property, this kind of aluminum sheet is widly used in trucks and cold storage floor.
5000 series checker plate especially alloy 5052 is used many humid environment such as watercraft.They have load capacity nature.